Tuesday 17 April 2012

Next in the queue for some attention

The SU carb, was an experiment that worked out quite well, a reconditioned HS2 1.25" carb originally set up for a Morris Minor 1000 car. It hasnt been changed from the Morris setup, I'm sure the carburation can be improved considerably, so I have been doing some homework!


Thursday 12 April 2012

Final drive ratios

While i have the scout on the lift, i decided to take note of some figures, to gelp get the best out of the stroker motor. I know that these figures will give me only theoretical top speeds etc but its good to know what gearing changes will do to your rev/speed ratio once you are on the road.
First off, with the cylinders fitted set the rear piston to tdc and put a chalk mark on the rear tyre, selected 1st gear and rotated the wheel for one full revolution of the crank... measured the distance travelled, same again for 2nd and top gear.






The Scout is fitted with a 24t gearbox/trans sprocket and a BSA qd rear wheel with a 49t sprocket giving a final drive ratio of 2.04:1

The BSA hub won't give me much scope for sprocket changes, so I'm thinking of changing to a Honda CB72e rear hub, with the advantage of a TLS rear brake, to let me try a range of sprocket sizes.... I reckon an FDR of 1.5:1 should work with the motor without losing too much acceleration




Saturday 7 April 2012

Trial fit alloy 648 tank

Mounting tabs will need some reinforcement but they are a nice neat fit






- Posted using BlogPress from my iPhone

Friday 6 April 2012

Compression Ratio figures

Checking the variance between front and rear cylinders without gaskets, with 1mm copper and with used compressed James gasket








- Posted using BlogPress from my iPhone

Wednesday 4 April 2012

Tanks for comparison

Tank on the left chromed steel Junior Scout weighing in at 2.88kg the tank on the right an aluminium 648 Scout spec tank, its LH partner weighs in at 1.65kg ... Bigger bulkier but almost half the weight!




- Posted using BlogPress from my iPhone